A few tips for easier board loading…
– Click Here for a video showing one of the easiest ways to load a board. It works for different lengths of boards and folks of different sizes. Thule and Yakima both have rods that extend out from your rack bars which provide
|Inflatable and epoxy boards on my loaner car
another option for this technique.
– In high winds, ask a buddy to help you load your boards. I’ve seen boards fly off cars, something to avoid. Once you’ve put a board on the car, strap down at least one side if you’re going to walk away or chat with friends.
– Fin up or fin down? Surfers may tell you to go fin up over the windshield to avoid losing the board if your straps are loose. But if you check your straps for tightness, then this won’t happen. I tighten each strap by falling back or down thus applying as much tightness as possible. If loading multiple boards and each have fins in, then go fins up offsetting the fins behind each or even on separate ends of the car. If only one board, either fin up or down works fine. For my Subaru Forester, a fin down over the hatchback makes it difficult to access the rear of the car. I remove fins for multiple board stacking.
– Have extra strap left over after tightening? I tightly wrap loose ends around the rack towers and/or bars then secure in case a buckle fails. Buckles can fail so think as safe as possible. Others may throw their strap ends into the car then close the door.
– Twist your rack straps while tightening. This helps prevent straps from whistling while underway. Check for
tightness after a few miles on the road as the twists can extend thus loosen up.
– For long distance drives, I like to make my car more efficient by pushing the boards back as far as possible above the windshield which helps with wind resistance.
– I prefer straps from Thule, Dakine, Seattle Sports and Mile22 which have texture which prevents the buckles from slipping as much. I don’t use ratchet straps as they can get too tight and damage your board. After I secure the buckle, I do one knot with the strap next to the buckle in case it fails or slips.
– Watch Robert Stehlik of Blue Planet Surf tie a board to his car in 30 seconds. Note that he does a shake test of the board at the end of the video. Definitely recommended!
Search this Blog for more tips on loading a SUP or Kayak on a car. I have several posts on the subject.
|Inflatables deflated and sandwiched between epoxy boards